SILOS Runs in Command Line and GUI Modes

006_command_line : SILOS Runs in Command Line and GUI Modes

Minimum Required Versions: SILOS 4.12.1.C

Example 006_command_line demonstrates running a SILOS simulation from the command line or using the SILOS GUI. The netlist used for this example was generated from a Gateway schematic of a switch level 2 input nor gate.

Simulate Netlist from Command Line

  • Open a command window.
  • Change directory the silos_006 example directory.
  • Run the command "silos -b testbench.v".
  • Observe the simulation results in the command window.

Simulate Netlist using SILOS GUI

  • Start SILOS from the icon or using the command "silos" from the command prompt.
  • Open the project file "nor.spjx".
  • Click on the "Go" toolbar button.
  • Observe the simulation results in the output window.